Jettrim Hydrospace S4 Mat Kit

Description

The Hydrospace Extended Tray Kicker can be purchased at the following link.
https://prowatercraftracing.com/product/hfc-hydrospace-kicker-tray-extension/

Jettrim makes the best traction mat kits including their setup for the Hydrospace S4 using high-quality, maximum-traction materials. Available in your choice of colors and materials to customize your ski for your personal style. This mat kit includes bottom mat, sides, dash, foam side risers, under mat padding and 1″ wedge rear kicker. With the tray risers your HSR sides will be raised to the same height as an SXR tray! 

Please refer to the product images for colors and features.

• This product fits: Hydrospace S4
  
• Installation time: Typical installation time 2.5 hours
• Download Jettrim installation manual

• Is it hard to remove my old mats?
  No, you can easily peel most stock mats by leaving your ski in the sun to heat the old adhesive and peel away the old mats.  This is the most simple solution.
  
• What’s the best adhesive to put on my new mats?
  We suggest using DAP Well Wood or 3M brush-on contact cement products.  No spray-on glue or adhesive product.
• How do I put them on?
  After removal of the old mats and adhesive completely you will lightly sand the surface where the mats are to be applied.  Scuffing the surfaces gives better grab to the new materials.  After applying adhesive to the back side of the new mats you will place very carefully place and adjust the mat as to not smear the adhesive.  Hold for a few to allow to dry and let set up before taking to the water!  Another tip-use superglue around the edge of the trim to finish the job!