Kawasaki 650SX / X2 Intake Pump Stuffer

(1 customer review)

$99.00

Description

Our Intake Pump Stuffers for the Kawasaki 650SX are simple to install and gain 2+ MPH affordably. To achieve this gain, our stuffer fills in the air pocket in the pump tunnel created while riding your ski. The air pocket is created while water is rushing over the unused area of the pump tunnel. This action drags water and creates cavitation making you lose power and drive. When you install this pump stuffer, you will see more drive and feel more ‘sucked down’ to the water.

The recommended intake grate is the WORX WR202 for the 650 / X2.

What You Need to Know:

  • Silicone is not included. We sell our tested High-Quality RTV Silicone. Use of any other type of silicone, adhesive, etc. will void the warranty.
  • Our silicone requires about 24 hours to cure. Using the product before the cure time will void the warranty.
  • This product will need to be checked a couple times each season. Failure to inspect the stuffer seal may result in damage to your impeller, pump, or more.
  • Some aftermarket intake grates (top loaders specifically) will decrease speed or performance.

Installation section

  • This product fits: Kawasaki 650SX (all years)
  • What’s included: Pump stuffer and instructions
  • Installation time: 1 hour

General install directions:

  1. Silicone the edges of the intake pump stuffer.
  2. Fit around the driveshaft.
  3. Push into place.
  4. Clean / Smooth the edges.
  5. Clean / Wipe the stuffer surface.

  • Can I install this without removing the pump?
    Yes, we do offer the option on some model standups to put a slit down the center. However, the best performance gain is removing the pump and sliding the stuffer over the driveshaft. The video above shows a pump stuffer with a slit being installed on a Kawasaki 650sx. If the slit stuffer is really difficult to install, you can chamfer the slit edge on the part number side to make the install smooth. No slit is even easier!
  • How does this secure to my ski?
    The part attaches to your pump tunnel with silicone adhesive. We sell our tested High-Quality RTV Silicone. Use of any other type of silicone, adhesive, etc. will void the warranty. This product will need to be checked a couple times each season. Failure to inspect the stuffer seal may result in damage to your impeller, pump, or more.
  • Does this stuffer work with a “top loader” intake grate?
    Typically, our pump tunnel stuffers perform the same function as a “top loader” intake grate, increasing top speed, but while keeping the same bottom end performance. We do not recommend using our stuffer with the “top loader” intake grate.
  • Is this part legal to race with?
    You will need to check the rules from your racing organization to verify if this part is legal for competition. ProWatercraft takes no responsibility if you are disqualified from this part breaking any racing organization rules.

Additional information

Weight 2 lbs
Dimensions 12 × 6 × 3 in

1 review for Kawasaki 650SX / X2 Intake Pump Stuffer

  1. L. Venditto

    Increased hook up and acceleration with minimal work and instant results! Easy installation and great fitment!

Add a review

You may also like…

Is there anything we can help you with?

Enter your details below to save your shopping cart for later. And, who knows, maybe we will even send you a sweet discount code :)